Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails
Nectar Collector E-Nail Barrel 10mm Coil - Discount E-Nails

Nectar Collector E-Nail Barrel 10mm Coil

$34.99$39.99

Nectar Collector E-Nail Barrel 10mm Coil

For: 110v Box - 100w coil
Coil size is the inner diameter in millimeters

See PIN diagram photo for fitment:
Pin1: Thermocouple-
Pin 2 Thermocouple+
Pin 3 : Ground
Pin 4 Power
Pin 5 Power
 
There are a few different ways other manufacture's wire their E-nail controller boxes/coils. These coils don't work with every brand of E-Nail controller box but can easily be DIY re-wired/soldered.
 
The coils will fit any E-Nail controller box sold by Discount E-Nails, except the "Crossing" brand E-Nail controllers, Dabpress, and Pack Science. We sell those coils separately. 
 
-90 day warranty on the coil-
 
Technical Details
Brand: Fancier
Coil Inner Diameter: 10mm
100w
5PIN XLR Connection
Coil height: 12.7mm
Item Weight: 3.05 ounces  
Coil tube size: 3*3mm square
Resistance Wire: Nickel chrome
Thermocouple: K-type
Cable length: 51 Inches
Material: Stainless steel
Sheath: Fire Resistant Kevlar

 

Customer Reviews

Based on 1 review
0%
(0)
0%
(0)
0%
(0)
0%
(0)
100%
(1)
J
JAMES ZACCARO
10mm coil e-nail

Never was able to use the coil as it was defected apon delivery. I assume the thermocouple or one of the sensors or components involved is defective. The display shows the temp in the negative and rapidly decreases as the coil begins to heat up. This happens for a few seconds at the most then the display reads EEEE and the coil stops increasing in temp. Other coils work fine on the same box. The same error happens when attempting to use defective coil on an alternate box. So I assume the heating element is fine, however the defective thermocouple sensor, or similar component renders the coil useless.